BOSS EDITION – 3D Acrylic Car Badge, Fender Emblem, 1 Pc

Trim badges belong where the factory would have put them: the tailgate corner, the bedside, or the front fender behind the arch. Put BOSS EDITION somewhere a manufacturer never would and it immediately reads as aftermarket.

Where it goes

Fender, tailgate, trunk lid or lower door - anywhere the surface is smooth, flat and sealed. Avoid textured bumper covers, plastic cladding and rough trim: those surfaces are made rough so adhesive will not key to them. If a panel is crowned, sight along the badge first and check that daylight does not show under the middle.

How it is made

3mm cast acrylic, laser cut and hand polished, with chamfered edges and UV-stable pigment layers. The color is in the material rather than printed on it, so wear shows as a scratch instead of exposing white substrate.

Sizes and colors

Pick a size, then set the base and text finishes independently. On black and dark gray cars, mirror silver reads furthest. On white and silver cars, gloss black is the finish that photographs best. Mirror finishes add $15 per layer.

Installation

Pre-applied 3M automotive tape. Clean, peel, position, press for thirty seconds. Because nothing is drilled, the badge comes off later with fishing line and a little heat without leaving a hole in the panel.

The quantity discount is calculated per product: two of the same badge takes 10% off, three takes 15%, and four or more takes 20%.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.