GRIM REAPER – 3D Acrylic Car Badge, Fender Emblem, 1 Pc

Smaller generally wins with character designs. GRIM REAPER at six or eight inches reads as a detail someone notices walking past; at twelve inches on a door it starts to read as a wrap.

Where it goes

Fender, tailgate, trunk lid or lower door - anywhere the surface is smooth, flat and sealed. Avoid textured bumper covers, plastic cladding and rough trim: those surfaces are made rough so adhesive will not key to them. If a panel is crowned, sight along the badge first and check that daylight does not show under the middle.

Build

Two layers of 3mm cast acrylic, laser cut, hand polished, chamfered on every edge. UV-stable pigment runs through the material, so it does not fade to pastel the way printed vinyl does after a couple of summers.

Sizes and colors

Pick a size, then set the base and text finishes independently. On black and dark gray cars, mirror silver reads furthest. On white and silver cars, gloss black is the finish that photographs best. Mirror finishes add $15 per layer.

Installation

3M automotive tape is applied before it ships. Clean the panel with isopropyl, peel, position, press for thirty seconds. No drilling, no fasteners, nothing to rust - and it removes cleanly with fishing line and gentle heat if you ever want the car back to stock.

The quantity discount is calculated per product: two of the same badge takes 10% off, three takes 15%, and four or more takes 20%.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.