LAST EDITION – 3D Acrylic Car Badge, Fender Emblem, 1 Pc

Trim badges belong where the factory would have put them: the tailgate corner, the bedside, or the front fender behind the arch. Put LAST EDITION somewhere a manufacturer never would and it immediately reads as aftermarket.

Where it goes

Fender, tailgate, trunk lid or lower door - anywhere the surface is smooth, flat and sealed. Avoid textured bumper covers, plastic cladding and rough trim: those surfaces are made rough so adhesive will not key to them. If a panel is crowned, sight along the badge first and check that daylight does not show under the middle.

Build

Two layers of 3mm cast acrylic, laser cut, hand polished, chamfered on every edge. UV-stable pigment runs through the material, so it does not fade to pastel the way printed vinyl does after a couple of summers.

Sizes and colors

Pick a size, then set the base and text finishes independently. On black and dark gray cars, mirror silver reads furthest. On white and silver cars, gloss black is the finish that photographs best. Mirror finishes add $15 per layer.

Installation

Peel, align, press. The 3M automotive tape is pre-applied, so the only thing that matters is a clean, dry surface - wipe the panel with isopropyl first and hold the badge down for a full thirty seconds. No tools and no holes in the paint.

The quantity discount is calculated per product: two of the same badge takes 10% off, three takes 15%, and four or more takes 20%.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.