MoparAzteca – 3D Acrylic Car Badge, Fender Emblem, 1 Pc

Some cars earn a name. MoparAzteca is laser cut and hand polished from cast acrylic, with the color running through the material - a scrape shows as a scratch rather than stripping the design back to white.

Where it goes

On a Charger or Challenger: the front fender behind the wheel arch, the trunk lid, or the lower door below the crease. On a RAM: the tailgate, the bed sides, and the fender flare flats. Avoid textured plastic bumper covers and any panel with an active body line running through the middle of the badge.

Materials and finish

Laser cut from 3mm cast acrylic and hand polished, with chamfered edges and UV-stable pigment. Built for full sun, rain, road salt and automatic car washes without fading or lifting.

Color options

The base plate and the text layer are chosen separately, from fifteen solid colors and five mirror finishes each. Mirror is real mirrored acrylic rather than a coating, so it does not scuff off at the edges; it adds $15 per layer.

Installation

Pre-applied 3M automotive tape. Clean, peel, position, press for thirty seconds. Because nothing is drilled, the badge comes off later with fishing line and a little heat without leaving a hole in the panel.

The quantity discount is calculated per product: two of the same badge takes 10% off, three takes 15%, and four or more takes 20%.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.