SILVERAYRO – 3D Acrylic Car Badge, Fender Emblem, 1 Pc

Short text reads best on a car. SILVERAYRO is sized so the lettering stays sharp at distance instead of blurring into a strip the way long phrases do.

Where it goes

The bedside flat above the rear wheel arch is the best surface on a Silverado or Sierra and the most visible. The tailgate either side of the handle and the front fender at door-handle height both work too. Skip the bed rail caps - they are textured plastic and tape will not key to them.

Build

Two layers of 3mm cast acrylic, laser cut, hand polished, chamfered on every edge. UV-stable pigment runs through the material, so it does not fade to pastel the way printed vinyl does after a couple of summers.

Color options

The base plate and the text layer are chosen separately, from fifteen solid colors and five mirror finishes each. Mirror is real mirrored acrylic rather than a coating, so it does not scuff off at the edges; it adds $15 per layer.

Installation

Pre-applied 3M automotive tape. Clean, peel, position, press for thirty seconds. Because nothing is drilled, the badge comes off later with fishing line and a little heat without leaving a hole in the panel.

The quantity discount is calculated per product: two of the same badge takes 10% off, three takes 15%, and four or more takes 20%.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.