V8 GO KART – 3D Acrylic Car Badge, Fender Emblem, 1 Pc

Displacement and induction badges are the oldest shorthand in car culture. V8 GO KART is laser cut from 3mm cast acrylic in two layers, with the color running through the material rather than printed on top of it.

Where it goes

Fender, tailgate, trunk lid or lower door - anywhere the surface is smooth, flat and sealed. Avoid textured bumper covers, plastic cladding and rough trim: those surfaces are made rough so adhesive will not key to them. If a panel is crowned, sight along the badge first and check that daylight does not show under the middle.

Build

Two layers of 3mm cast acrylic, laser cut, hand polished, chamfered on every edge. UV-stable pigment runs through the material, so it does not fade to pastel the way printed vinyl does after a couple of summers.

Color options

The base plate and the text layer are chosen separately, from fifteen solid colors and five mirror finishes each. Mirror is real mirrored acrylic rather than a coating, so it does not scuff off at the edges; it adds $15 per layer.

Installation

Pre-applied 3M automotive tape. Clean, peel, position, press for thirty seconds. Because nothing is drilled, the badge comes off later with fishing line and a little heat without leaving a hole in the panel.

The quantity discount is calculated per product: two of the same badge takes 10% off, three takes 15%, and four or more takes 20%.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.