Veloster – 3D Acrylic Car Badge, Fender Emblem, 1 Pc

Short text reads best on a car. Veloster is sized so the lettering stays sharp at distance instead of blurring into a strip the way long phrases do.

Where it goes

Front fender behind the wheel arch, lower door below the crease, or the boot lid to one side of the handle. Stingers have a pronounced crown across the rear quarter - check for daylight under the middle of the badge before committing to that panel.

Build

Two layers of 3mm cast acrylic, laser cut, hand polished, chamfered on every edge. UV-stable pigment runs through the material, so it does not fade to pastel the way printed vinyl does after a couple of summers.

Color options

The base plate and the text layer are chosen separately, from fifteen solid colors and five mirror finishes each. Mirror is real mirrored acrylic rather than a coating, so it does not scuff off at the edges; it adds $15 per layer.

Installation

Pre-applied 3M automotive tape. Clean, peel, position, press for thirty seconds. Because nothing is drilled, the badge comes off later with fishing line and a little heat without leaving a hole in the panel.

The quantity discount is calculated per product: two of the same badge takes 10% off, three takes 15%, and four or more takes 20%.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.