500 STROKER 8.2L – 3D Acrylic Car Badges, Set of 2

An engine callout answers the question before anyone asks it. 500 STROKER 8.2L is cut as a two-layer acrylic badge, so the lettering stands proud of its base plate and throws a shadow instead of sitting flat against the panel like a decal.

Where it goes

Fender, tailgate, trunk lid or lower door - anywhere the surface is smooth, flat and sealed. Avoid textured bumper covers, plastic cladding and rough trim: those surfaces are made rough so adhesive will not key to them. If a panel is crowned, sight along the badge first and check that daylight does not show under the middle.

Materials and finish

Laser cut from 3mm cast acrylic and hand polished, with chamfered edges and UV-stable pigment. Built for full sun, rain, road salt and automatic car washes without fading or lifting.

Sizes and finishes

Choose your size, then pick a base finish and a text finish independently - fifteen solid colors and five mirror options on each layer. Mirror adds $15 per layer. Dark base with mirror or white text is the combination that reads hardest at distance.

Installation

Pre-applied 3M automotive tape. Clean, peel, position, press for thirty seconds. Because nothing is drilled, the badge comes off later with fishing line and a little heat without leaving a hole in the panel.

This is a set of two - one for each side. Fender badges look wrong fitted to one side only, which is why these ship as a pair.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.