7.0L 427 STROKER – 3D Acrylic Car Badges, Set of 2

An engine callout answers the question before anyone asks it. 7.0L 427 STROKER is cut as a two-layer acrylic badge, so the lettering stands proud of its base plate and throws a shadow instead of sitting flat against the panel like a decal.

Where it goes

Fender, tailgate, trunk lid or lower door - anywhere the surface is smooth, flat and sealed. Avoid textured bumper covers, plastic cladding and rough trim: those surfaces are made rough so adhesive will not key to them. If a panel is crowned, sight along the badge first and check that daylight does not show under the middle.

Build

Two layers of 3mm cast acrylic, laser cut, hand polished, chamfered on every edge. UV-stable pigment runs through the material, so it does not fade to pastel the way printed vinyl does after a couple of summers.

Sizes and colors

Pick a size, then set the base and text finishes independently. On black and dark gray cars, mirror silver reads furthest. On white and silver cars, gloss black is the finish that photographs best. Mirror finishes add $15 per layer.

Installation

3M automotive tape is applied before it ships. Clean the panel with isopropyl, peel, position, press for thirty seconds. No drilling, no fasteners, nothing to rust - and it removes cleanly with fishing line and gentle heat if you ever want the car back to stock.

This is a set of two - one for each side. Fender badges look wrong fitted to one side only, which is why these ship as a pair.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.