392, Style 3 – 3D Acrylic Car Badges, Set of 2

Displacement and induction badges are the oldest shorthand in car culture. 392 is laser cut from 3mm cast acrylic in two layers, with the color running through the material rather than printed on top of it.

Where it goes

On a Charger or Challenger: the front fender behind the wheel arch, the trunk lid, or the lower door below the crease. On a RAM: the tailgate, the bed sides, and the fender flare flats. Avoid textured plastic bumper covers and any panel with an active body line running through the middle of the badge.

How it is made

3mm cast acrylic, laser cut and hand polished, with chamfered edges and UV-stable pigment layers. The color is in the material rather than printed on it, so wear shows as a scratch instead of exposing white substrate.

Color options

The base plate and the text layer are chosen separately, from fifteen solid colors and five mirror finishes each. Mirror is real mirrored acrylic rather than a coating, so it does not scuff off at the edges; it adds $15 per layer.

Installation

Pre-applied 3M automotive tape. Clean, peel, position, press for thirty seconds. Because nothing is drilled, the badge comes off later with fishing line and a little heat without leaving a hole in the panel.

This is a set of two - one for each side. Fender badges look wrong fitted to one side only, which is why these ship as a pair.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.