Land Cruiser – 3D Acrylic Car Badge, Fender Emblem, 1 Pc

Short text reads best on a car. Land Cruiser is sized so the lettering stays sharp at distance instead of blurring into a strip the way long phrases do.

Where it goes

Bedside flat above the rear arch, tailgate clear of the stamped lettering, or the front fender behind the wheel arch. Two surfaces to avoid on a Tacoma or 4Runner: the textured bed rail caps and the plastic lower cladding. Both are rough by design and both are where people try to mount first.

Build

Two layers of 3mm cast acrylic, laser cut, hand polished, chamfered on every edge. UV-stable pigment runs through the material, so it does not fade to pastel the way printed vinyl does after a couple of summers.

Sizes and colors

Pick a size, then set the base and text finishes independently. On black and dark gray cars, mirror silver reads furthest. On white and silver cars, gloss black is the finish that photographs best. Mirror finishes add $15 per layer.

Installation

Peel, align, press. The 3M automotive tape is pre-applied, so the only thing that matters is a clean, dry surface - wipe the panel with isopropyl first and hold the badge down for a full thirty seconds. No tools and no holes in the paint.

The quantity discount is calculated per product: two of the same badge takes 10% off, three takes 15%, and four or more takes 20%.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.