324is, Style 2 – 3D Acrylic Car Badge, Fender Emblem, 1 Pc

324is is the kind of badge that starts a conversation at a fuel stop. Cut from two layers of 3mm cast acrylic, with the text raised off a continuous base plate so it catches light rather than lying flat.

Where it goes

European panels are more crowned than they look. Hold the badge against the surface and sight along it at a low angle - if daylight shows under the middle while the ends touch, move it. The dependable flats are the front fender behind the arch, the lower door below the crease, and the boot lid to one side of the handle.

Build

Two layers of 3mm cast acrylic, laser cut, hand polished, chamfered on every edge. UV-stable pigment runs through the material, so it does not fade to pastel the way printed vinyl does after a couple of summers.

Sizes and finishes

Choose your size, then pick a base finish and a text finish independently - fifteen solid colors and five mirror options on each layer. Mirror adds $15 per layer. Dark base with mirror or white text is the combination that reads hardest at distance.

Installation

Peel, align, press. The 3M automotive tape is pre-applied, so the only thing that matters is a clean, dry surface - wipe the panel with isopropyl first and hold the badge down for a full thirty seconds. No tools and no holes in the paint.

The quantity discount is calculated per product: two of the same badge takes 10% off, three takes 15%, and four or more takes 20%.

3mm cast acrylic, laser cut and hand polished. Chamfered edges, UV-stable pigment layers.

Pre-applied 3M automotive tape. Clean, peel, position, press for 30 seconds. Alignment template included.

Made to order in 1-3 business days. Free USA shipping over $20.